
Start-Up
Axiostar plus Attaching condensers Carl Zeiss
B 40-815 e 12/01 2-17
Operation with 9 V Alkaline battery
(9 V / Ni Cd battery block)
• Turn holding screw (2-16/8) on the cover
(2-16/7) of the battery compartment to the
left and remove the cover.
• Insert 9 V Alkaline battery (2-16/6) into the
battery compartment (2-16/5) with the
terminals in front (plus pole points
upwards).
• Attach cover, press it on and fix it in
position by turning the holding screw to the
right.
Operation with external voltage supply
• Insert angled connector of the 12 V battery-
adapter cable (2-16/11) into the +12 V
socket (2-16/2) of the LED illuminator.
• Connect cable clamps of the 12 V battery-
adapter cable (2-16/11) to the used 12 V
battery:
red clamp to plus pole (+),
black clamp to minus pole (-).
Depending on the brightness set via the control
(2-16/3), the integrated current control
guarantees constant brightness as long as there
is sufficient loading capacity from the battery. If
the loading capacity is exhausted, the LED
illuminator will go out or drop to minimum
brightness.
• After connection to the voltage source,
switch the LED illuminator on or off via the
toggle switch (2-16/4).
• Match the illumination intensity via the
control (2-16/3).
Operation with battery pack C
• Use the included connection cables to
connect a 12 V connection box on the
battery pack C (cigarette lighter) with the
12V connection box on the LED illuminator.
For further details regarding the battery pack C,
please see the applicable operating manual.
1 LED illuminator
2 +12 V socket
3 Control
4 Toggle switch
5 Battery compartment
6 9 V Alkaline battery
7 Cover
8 Holding screw
9 Power unit
10 Country-specific adapter
11 12 V battery-adapter cable (4 m long)
12 Cable holder
Fig. 2-16 Connecting LED illuminator to power
source
Make absolutely sure to avoid moistening of
the 12 V battery-adapter cable with liquids.
Komentáře k této Příručce