
9
Pull the analyzer located on the left side of the microscope to the left so that it is in position
shown in (Fig. 10).
Figure 7
The polarizer for DIC imaging
Figure 8
The analyzer for DIC imaging
Rotate the condenser to the correct DIC position (Fig. 5). Each DIC position is marked with a
range (e.g. ..3-.4). Numerical aperture of the objective must fit into that range.
Above the polarizer, there is a slider that is used for adjusting the angle between the
polarizing plane of the polarizer and analyzer. Move the slider while looking at the DIC
image.
The angle of the DIC-slider is adjusted with the little knob (Fig. 11). It affects the pseudo3D-
effect that the DIC imaging creates.
Figure 9
The knob for adjusting the angle of the DIC-slider
Komentáře k této Příručce